That process shouldn’t have taken very long at all, and the good news about it is that you won’t have to do it again. Regardless, you’re now ready for the format. It still took the software less than maybe 10 seconds to shoot the relevant information out. We were working with a disk that was 2 metric terabytes, which comes to 1.8 terabytes in binary. Depending on how massive your drive is, this might take a few seconds. It should give you a message about HPFS/NTFS/exFAT, which is exactly what you want if you’re looking to format your external disk with exFAT on Linux.įinally, you simply have to push the w key and you’ll be warned that “The partition table has been altered” before fdisk syncs all the data out to disk. You can then push 7 to the expected type. Push the letter t and then push the enter key so you can change the type. You might notice a problem though – the partition type is currently showing up as Linux, which you’re going to have a tough time reading on any of these kinds of machines! This will create one giant partition that takes over your whole disk, which is exactly what you want if you’re going to be plugging this into a macOS computer, a Windows 10 PC or any compatible mobile device. Type enter once more when asked about the first and last sectors. Type enter again, then again to create a single partition. You’ll get a message about creating a new DOS table or something of the sort, which is simply safe to ignore. Please make sure you’re working with the right device file to avoid mucking anything up. Next, you’ll want to type sudo fdisk /dev/sdb and push enter so you can make a new partition table. Assuming you wanted to destroy everything on it and start fresh with a new exFAT file system, type sudo wipefs -a /dev/sdb so you can start fresh. Needless to say, proceeding is going to wipe the data structures off your drive so please make sure to have backups before you loose anything you want. We plugged a pretty good sized USB drive into our system and found it showing up as /dev/sdb, which you could easily format. If you have a /dev/sda1 and so on device in your list, then this is very often what you boot GNU/Linux off of. Pay very close attention to make sure that you don’t format the wrong drive. You’ll see a full list of devices that are attached to your system. If you don’t know the name of the drive that you need to format, then type sudo fdisk -l at the command line and push enter.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |